What we supply in 13/16-20 UNEF
Thread plug gages
GO and NO GO (HI) members, double-end or single-end, for checking 13/16-20 UNEF-2B and -3B tapped holes and nuts.
Thread ring gages
GO and NO GO (LO) rings for checking 13/16-20 UNEF-2A and -3A screws, studs, and machined external threads.
Set plugs & specials
Truncated and full-form set plugs for ring setting, plus modified pitch diameters, plated-thread and built-to-print gages quoted to your drawing.
Gages are supplied to ASME B1.2 gagemaker tolerances. Tell us the class, gage type, and quantity, and whether you need a calibration certificate with delivery.
Pitch diameter limits the gages check
A GO thread plug sits at the minimum pitch diameter of the internal thread and a NO GO (HI) plug at the maximum. A GO thread ring sits at the maximum pitch diameter of the external thread and a NO GO (LO) ring at the minimum. These are the product limits for 13/16-20 UNEF, in inches:
| Class | Thread | Pitch dia min | Pitch dia max | Major dia min | Major dia max | Checked by |
|---|---|---|---|---|---|---|
| 2A | External | 0.7743 | 0.7787 | 0.8031 | 0.8112 | Thread ring gages |
| 3A | External | 0.7767 | 0.7800 | 0.8044 | 0.8125 | Thread ring gages |
| 2B | Internal | 0.7800 | 0.7858 | — | — | Thread plug gages |
| 3B | Internal | 0.7800 | 0.7843 | — | — | Thread plug gages |
Computed from the ASME B1.1 formulas, with tolerances based on a length of engagement equal to nine pitches (9p), as ASME B1.1 specifies for the UNEF series. Class 2A carries an allowance of 0.0013"; class 3A has none. These are reference values: ASME B1.1 is the controlling document, and in a few sizes its published tables differ from the formula result by 0.0001" in the last place. Verify against the current standard before using them for acceptance.
Three-wire measurement
Measuring a 13/16-20 UNEF-2A thread over wires with the best wire size of 0.02887", the measurement over wires runs from 0.81760" at minimum pitch diameter to 0.82200" at maximum, without lead angle correction. Enter your own wire size and reading in the three-wire pitch diameter calculator.
Calibration for 13/16-20 UNEF gages
Already have 13/16-20 UNEF gages in your crib? We manage their calibration through ISO/IEC 17025-accredited partner laboratories, at published prices: $12.00 per thread plug member and $19.00 per thread ring (standard pitch diameters, up to 2"). Each certificate is issued by the accredited lab that performs the work, with as-found and as-left data. Typical turnaround is 3 to 5 business days.
About the UNEF series
The extra-fine series is used where wall thickness is limited or fine adjustment is needed: thin-wall fittings, tube nuts, and short engagement lengths. 13/16-20 UNEF has 20 threads per inch on a 0.8125" nominal diameter.